Table of Contents
Advertisement
9 Setup of Extended Baud Rate
9.1
Setup of Extended Baud Rate (in Master Mode)
1)
Connect the device to the Devicenet network according to the following figure. The PC accesses the PLC via
RS232 or RS485.
Note: Different PLC corresponds to different device addresses. For details, please refer to Input and Output
Mapping Areas in Section 4.2. We take DVP-SV as the PLC for description below.
2)
Open DeviceNet Builder software and select "Setup" => "Communication Setting" => "System Channel". And
then the following dialog box appears.
3)
Set up the communication parameters for the PC and DVP-SV, e.g. the communication port, address, baud
rate and communication format. Click on "OK" after the configuration is finished.
Item
COM Port
Address
Baud rate
Data Bits
Parity
Stop Bit
Mode
4)
Select "Network" => "Online" and the following "Select Communication Channel" dialog box will appear. Click
on "OK".
DVP-PLC Operation Manual
DeviceNet Network Scanner DVPDNET-SL
Function
COM port on the PC to be used to communicate
with DVP-SV
Communication address of DVP-SV
Communication speed between the PC and
DVP-SV
Communication protocol between the PC and
DVP-SV
Communication mode between the PC and
DVP-SV
DVPDNET-SL
DVP28SV
DeviceNet Builder
Default
COM1
1
9,600 (bps)
7
Even Parity
1
ASCII
27
Advertisement
Table of Contents
