Table of Contents
Advertisement
VFD-L
parameter
02-00
02-01
09-00
09-01
09-04
10.2 How to Configure DeviceNet Network
1)
Configuring DeviceNet slave
1> Open DeviceNet Builder software and select "Setup" => "Communication Setting" => "System
Channel", and then the "Serial Port Setting" dialog box will appear as below.
2> Set up the communication parameters for the PC and DVP-SV, e.g. the communication port, address,
baud rate and communication format. Click on "OK" after the configuration is finished.
COM Port
Address
Baud rate
Data Bits
DVP-PLC Operation Manual
DeviceNet Network Scanner DVPDNET-SL
Setting
4
Transmit the frequency of VFD-L via RS485.
3
Control the operation of VFD-L via RS485.
1
Set the node address of VFD-L in Modbus to 1.
1
Set the baud rate of VFD-L in Modbus to 9600
Set the communication format of VFD-L in Modbus to
1
7, E, 1, ASCII.
Item
COM port on the PC to be used to
communicate with DVP-SV
Communication address of DVP-SV
Communication speed between the PC and
DVP-SV
Communication protocol between the PC
Parity
and DVP-SV
Stop Bit
Communication mode between the PC and
Mode
DVP-SV
Description
Function
Default
COM1
1
9,600 (bps)
7
Even Parity
1
ASCII
33
Advertisement
Table of Contents
