Setup Of Extended Baud Rate (In Slave Mode) - Delta DVPDNET-SL Operation Manual

9.2

Setup of Extended Baud Rate (in Slave Mode)

1) Connect relevant devices to the DeviceNet network according to the following figure.
Note:
a. The DVPDNET-SL at the bottom of the figure above has been set to work in slave mode.
b. The node addresses of the two DVPDNET-SLs must not be identical. (See Section 2.4).
c. The baud rates of the two DVPDNET-SLs are both 500K bps (See Section 2.5).
d. Different PLC corresponds to different device addresses. For details, please refer to Input and Output
Mapping Areas in Section 4.2. We take DVP-SV as the PLC for description below.
2) Open DeviceNet Builder software and select "Setup" => "Communication Setting" => "System Channel" to
see the following dialog box.
DVP-PLC Operation Manual
DeviceNet Network Scanner DVPDNET-SL
DVPDNET-SL(Master)
DVP28SV
DeviceNet Builder
DeviceN et
DVP28SV
DVPDNET-SL(Slave)
29