Embroidering Preparation
Selecting the Stitch Plate in the User Interface
After changing the stitch plate, you can check whether it can be used with the selected needle.
> Tap «Stitch Plate/Needle Selection».
> Select Straight and CutWork Stitch Plate.
Thread-up Command
The machine must be ready for embroidery to bring up the bobbin thread. The bobbin thread can be
brought up in one step for a manual knotting. If no securing stitches are wanted, it is recommended to
deactivate the securing stitches in the Setup.
> Hold the upper thread.
> Push the button«Presser Foot Up/Down».
13.6 Embroidery Hoop
Overview Embroidery Hoop Selection
1
Selecting the Embroidery Hoop
The best embroidery result is achieved when the smallest possible embroidery hoop for the embroidery
design is selected.
The embroidery design has a pre-set size which is displayed.
Prerequisite:
•
138
–
The bobbin thread is brought up automatically.
Hoop Selection
The embroidery design is selected.
1