Selecting The Needle In The User Interface; Selecting The Needle Type And The Needle Size; Adjusting The Needle Position Up/Down; Adjusting The Needle Position Left/Right - Bernina 570 QE User Manual

Selecting the Needle in the User Interface

After changing the needle, you can check whether this can be used with the selected stitch plate.
> Tap «Stitch Plate/Needle Selection».
> Select the fitted needle.
– If the selected needle is suitable in combination with the selected presser foot, sewing can be started.
If the selected needle does not correspond with the selected presser foot, there will be an error
message when switching on the machine, and the machine will not start.

Selecting the Needle Type and the Needle Size

Useful reminder function: So that no information is lost, the needle type and needle thickness can also be
saved on the machine. This means that the saved needle type and needle thickness can be checked at any
time.
> Tap «Stitch Plate/Needle Selection».
> Tap «Needle Selection».
1
> Select the needle type (1) of the fitted needle.
> Select the needle type (2) of the fitted needle.

Adjusting the Needle Position Up/Down

> To lower the needle, push the button «Needle position Up/Down».
> To raise the needle, push the button «Needle position Up/Down» again.

Adjusting the Needle Position Left/Right

There is a total of 11 needle positions. The needle position is indicated by the needle position number in the
display.
> To position the needle position to the left, push the button «Needle Position Left» (1).
2
Sewing Preparation
41