Bernina 570 QE User Manual page 45

> Push the semi-automatic needle-threading lever (8) halfway down and pull the thread behind the grey
needle-threading finger/hook to the left (9).
8
9
> Guide the thread from the left to the right in front of the gray needle-threading finger/hook (11).
> Push the needle-threading lever down as far as it will go (10).
> Pull the thread from left to right (11) through the needle-threading slot (12) until it cathces on the wire
hook.
> Pull the thread over the thread cutter (13) from the back and cut.
10
11 12
> Release the needle-threading lever.
– The thread is pushed through the needle eye.
> Pull the loop of thread (14) to the rear until the end of the thread is pulled through the needle.
14
13
Sewing Preparation
45