Configuring The Lan Interface(S); Basic Settings - peplink PEPWAVE MAX Series User Manual
For more information, please visit peplink.com
Hide thumbs
Also See for PEPWAVE MAX Series:
- User manual (284 pages) ,
- User manual (260 pages) ,
- User manual (436 pages)
Table of Contents
Advertisement
8
Configuring the LAN Interface(s)
8.1
Basic Settings
LAN interface settings are located at Network>LAN>Network Settings . Navigating to that
page will show the following dashboard:
This represents the LAN interfaces that are active on your router (including VLAN). A grey "X"
means that the VLAN is used in other settings and cannot be deleted. You can find which
settings are using the VLAN by hovering over the grey "X".
Alternatively, a red "
VLAN by clicking the red "
Clicking on any of the existing LAN interfaces (or creating a new one) will show the following :
IP Address
Name
VLAN ID
Inter-VLAN routing
https://www.peplink.com
X
" means that there are no settings using the VLAN. You can delete that
X
"
IP Settings
The IP address and subnet mask of the Pepwave router on the LAN.
Network Settings
Enter a name for the LAN.
Enter a number for your VLAN.
Check this box to enable routing between virtual LANs.
103
Copyright @ 2021 Peplink
Advertisement
Table of Contents
