Dpi Engine; Netflow; Wi-Fi Air Monitoring; Sp Default Configuration - peplink PEPWAVE MAX Series User Manual

Click here for the full instructions on how to set up KVM
Click here for the full instructions on how to set up KVM with USB Storage
3.9

DPI Engine

The DPI report written in the updated KB article will show further information on InControl2
through breaking down application categories into subcategories.
https://forum.peplink.com/t/updated-ic2-deep-packet-inspection-dpi-reports-and-everythi
ng-you-need-to-know-about-it/29658

3.10 NetFlow

NetFlow protocol is used to track network traffic. Tracking information from NetFlow can be sent
to the NetFlow collector, which analyzes data and generates reports for review.
Note: To enable this feature, go to https://<Device's IP>/cgi-bin/MANGA/support.cgi
3.11

Wi-Fi Air Monitoring

Pepwave routers support Wi-Fi "Air Monitoring Mode" which used to troubleshoot remotely and
proactively monitor Wi-Fi and WAN performance. The report can be viewed under InControl 2 >
Reports > AirProbe Reports after enabling Wi-Fi Air Monitoring.
Note: To enable this feature, go to https://<Device's IP>/cgi-bin/MANGA/support.cgi
3.12 SP Default Configuration
The SP Default Configuration feature written in the updated KB article allows for the provisioning of
custom made settings (a.k.a. InControl2 configuration) via the Ethernet LAN port and is ideal for those
wanting to do a bulk deployment of many Peplink devices.
Note: If you would like to use this feature, please contact your purchase point (Eg.VAD) .
https://www.peplink.com 74 Copyright @ 2021 Peplink