Configuring The Lan Interface(S); Basic Settings - peplink PEPWAVE HD Dome Pro User Manual

8 Configuring the LAN Interface(s)
8.1

Basic Settings

LAN interface settings are located at Network>LAN>Network Settings . Navigating to that
page will show the following dashboard:
This represents the LAN interfaces that are active on your router (including VLAN). A gray "X"
means that the VLAN is used in other settings and cannot be deleted. You can find which
settings are using the VLAN by hovering over the gray "X".
Alternatively, a red "
VLAN by clicking the red "
Clicking on any of the existing LAN interfaces (or creating a new one) will show the following :
IP Address
Name
VLAN ID
Inter-VLAN routing
https://www.peplink.com
X " means that there are no settings using the VLAN. You can delete that
X "
IP Settings
The IP address and subnet mask of the Pepwave router on the LAN.
Network Settings
Enter a name for the LAN.
Enter a number for your VLAN.
Check this box to enable routing between virtual LANs.
105 Copyright @ 2021 Peplink