Installation; Preparation; Constructing The Network - peplink PEPWAVE MAX Series User Manual

4

Installation

The following section details connecting Pepwave routers to your network.
4.1

Preparation

Before installing your Pepwave router, please prepare the following as appropriate for your
installation:
● At least one Internet/WAN access account and/or Wi-Fi access information
● Depending on network connection type(s), one or more of the following:
○ Ethernet WAN : A 10/100/1000BaseT UTP cable with RJ45 connector
○ USB : A USB modem
○ Embedded modem : A SIM card for 5G/4G LTE service
○ Wi-Fi WAN : Wi-Fi antennas
○ PC Card/Express Card WAN: A PC Card/ExpressCard for the corresponding
card slot
● A computer installed with the TCP/IP network protocol and a supported web browser.
Supported browsers include Microsoft Internet Explorer 11 or above, Mozilla Firefox 24
or above, Apple Safari 7 or above, and Google Chrome 18 or above.
4.2

Constructing the Network

At a high level, construct the network according to the following steps:
1. With an Ethernet cable, connect a computer to one of the LAN ports on the
Pepwave router. Repeat with different cables for up to 4 computers to be
connected.
2. With another Ethernet cable or a USB modem/Wi-Fi antenna/PC Card/Express
Card, connect to one of the WAN ports on the Pepwave router. Repeat the same
procedure for other WAN ports.
3. Connect the power adapter to the power connector on the rear panel of the
Pepwave router, and then plug it into a power outlet.
https://www.peplink.com 76 Copyright @ 2021 Peplink