Audio Routing: Programs To Kdfx; Audio Routing: Kdfx To Audio Outputs - Kurzweil K2661 Musician's Manual

Audio Outputs

Audio Routing: Programs to KDFX

Audio Routing: Programs to KDFX
1. In any mode (typically Program mode), highlight a program name with the cursor, then
2. Press one of the more soft buttons until you see OUTPUT at the bottom of the display.
3. Set the value of the Pair parameter as desired. This value determines which KDFX input
4. Repeat this process for each layer in the program (or, if you're editing a setup, for every

Audio Routing: KDFX to Audio Outputs

Every program that uses KDFX has a studio assigned to it. The studio defines the KDFX
parameters for the program to which it's assigned.
1. In the Program Editor, press one of the more soft buttons until you see KDFX at the
2. Highlight the Studio parameter, then press Edit to enter the Studio Editor.
3. Press the OUTPUT soft button to view the OUTPUT page for the current studio. Note that
4. Set the values for each of the four Output parameters. These parameters represent the four
19-2
press Edit to enter the Program Editor. Note how many layers there are in the program.
Press the corresponding soft button to view the OUTPUT page for the current layer.
(A–D) gets the output from the current program layer.
layer of every program in the setup).
bottom of the display. Press the corresponding soft button to view the KDFX page for the
current layer.
it controls all layers of the program.
pairs of outputs; the parameters' values specify which KDFX output bus gets routed to
each of the analog outputs.