Kurzweil K2661 Musician's Manual page 192

Basic Effects Mode
A Simple Studio
frequency. In the input section for this example, the high frequencies are boosted 6.0 dB above
1568 Hz.
Sends
The third and fourth blocks determine the destinations of the Input A signal: each block can be
set to route the signal to any of the four insert FXBuses, or to None. You cannot, however, set
both blocks to the same destination.
The Lvl control is the FXBus send; it sets the level of the signal to the FXBus above it. In this
example, the level is backed off 6.0 dB, to compensate for the treble boost in the equalizer, so that
the signal doesn't overload the FXBus.
Pan determines the position of the signal respective to the left and right sides. Width (which is
not shown when you are using mono inputs) determines how much the left and right sides'
signals will be separated or blended.
The FXSEND Page
Press the more> soft button to display additional soft buttons for this page. Then press FXSEND
to see the FXSEND page:
|||||!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!h
Levels
There are two sets of level and pan controls from the FX preset to the output mixer. Use the first
set, Aux Lvl and Aux Pan, to specify how much of the sound will go to the global or Auxiliary
effects bus, and how its two channels are panned. On this FXBus, the signal to the Aux bus is
boosted 3.5 dB. The second set determines how much of the sound goes to the Mix bus. On this
FXBus, the Mix signal is attenuated -4.5 dB.
9-24
0wwwwt
K 1
CVVVVB
0wwwwt
K 1
CVVVVB