Kurzweil K2661 Musician's Manual page 222

MIDI Mode
Program Change Formats
When you're using this format, the K2661 will respond to MC 0 or 32 messages for selecting QA
banks, and to PCHs for selecting entries within the current bank. PCHs select entries according
to their "chronological" listing within the QA bank (not according to their IDs).
Command Type
MIDI controller 0 or 32
(MC 0 or MC 32)
Standard (PCH)
Depending on the QA bank entry you want to select, you'll send the K2661 either a PCH (value
0 to 99), or a MIDI Controller 0 or 32 message (value 0 to 7) followed by a PCH. Sending a single
command will let you select from a range of 10 QA banks and select an entry within that bank
(see the table below). To select a different range of QA banks, send an MC 0 or 32 message
followed by a PCH.
The MC 0 or 32 messages selects the range of QA banks (0s through 70s), while the PCH selects
the bank within that range, as well as the entry within that bank. Neither the MC 0 or 32 nor the
PCH selects a different memory bank (Zeros through 900s). In fact, you can't change the memory
bank via MIDI when using this format. All program and setup selections are made within the
currently selected memory bank. You'll know which memory bank is selected by looking at the
ID of the currently selected Quick Access bank in the top line of the Quick Access-mode page.
Several examples follow.
10-14
Range of
Result
Values
0 to 7 Selects QA bank 0n, 1n, 2n, 3n, 4n, 5n, 6n, 7n in current memory bank
8–127 Ignored
0–99 Selects last digit (n above) of QA bank, and entry within that bank
100–127 Ignored