Recmode - Kurzweil K2661 Musician's Manual

Parameter
Record Mode
Play Mode
Key Wait
Locate
Auto In
Auto Out
Input Quantize
Grid
Swing
Sync
Clock
Tempo
Countoff
Click
Click Channel
Click Program
Click Key
Click Velocity
The top line displays the amount of free event space and the current sequencer state, which is
one of the following: STOPPED, PLAYING, REC READY, RECORDING, KEY WAIT, or
EXT. CLOCK.

RecMode

When recording the first track of a new song, you will be able to record as if you had an endless
length of "tape" no matter what the recording mode is set to.
When you record the first track, all recording modes operate the same way. This is because until
you define the length of a new song, its End point is the default setting of Bar 8001, the
maximum amount of Bars in a song. The End point is referenced and modified in different ways
depending on the RecMode.
The End point of a song is defined when:
1. The Stop button is pressed to end the recording of the first track. The new End point is
aligned to the nearest downbeat of the (empty) Bar immediately following the last Bar you
were recording when Stop was pressed.
2. Stop is pressed while recording any track past the previously set End point in Linear or
UnLoop recording mode. Again, the new End point is aligned to the downbeat of the
(empty) Bar immediately following the last Bar you were recording when Stop was
pressed.
3. The AutoOut Bar and Beat is set past current End point, after recording in Auto RecMode,
and when the first track is recorded in Auto RecMode, the AutoOut Bar and Beat becomes
the End point.
Range of Values
Linear, Fixlen, Loop, Unloop, Auto
Linear, Loop, List, Chain
On, Off
-25:2 – 999:4
1:1 – 999:4
1:1 – 2500:
Off, 1% – 100%
1/1 – 1/384
-99% – 125%
Both, Xmit, Recv, Off
Int, Ext
Auto, Fixed
Off, 1, 2, 3
Off, Rec, On, Cnt
1 – 16
1 – 999
C-1 – G9
1 – 127
Song Mode and the Song Editor
Song Mode: The MISC Page
Default
Linear
Loop
Off
1:1
1:1
1:1
Off
1/8
0%
Off
Int
Auto
1
Rec
16
198
C4
100
12-33