Mounting the Motor Unit on the ceiling plate
What has to be
After the rods are inserted in the welded nuts on the ceiling plate, proceed to mounting
done
the Motor Unit onto the ceiling plate.
Necessary Tools
Spanner 18mm
Mounting the
To mount the Motor Unit on the ceiling plate, follow the next procedure:
Motor Unit
Step
1-
2-
3-
BARCO 12
Action
Line up the provided holes (A) in the motor unit with the four rods (B).
Attention: position the motor unit as illustrated in drawing below, side with the
2 belt drives (C) facing the rear of the projector.
Slide the motor unit over the rods fully against the locking nuts of the rods.
Put a nut M12 (D) on each rod (B) and turn it fully on the rod, tightening the
motor unit.
A
REAR
PROJECTOR
C
D
PROJECTOR
D
Projection Systems
B
FRONT