Projector Position Correction; What Has To Be Done; Necessary Tools; Projector Coarse Water-Level Adjustment - Barco R9828870 Instruction Manual

Projector position correction

What has to be After the Projector/support is attached to the rods, small corrections on the position of
done the projector with regard to the screen has to executed, as water-level and perpendicu-
larity of the projector to the screen.

Necessary Tools

Spanner 18mm -Flat screw driver
Projector COARSE To level (Coarse) the projector, follow the next procedure:
water-level
adjustment
Step
1-
2-
3-
Projector FINE To level (Fine) the projector, follow the next procedure:
water-level
adjustment
Step
1-
2-
3-

Illustrations

BARCO ———————————————————
Action
Loosen the nuts 1 on each rod and move these 2 cm upwards
Put a water-level on the projector, as well on the long side as on the short side
of the projector support, and level of the projector using the nuts 2.
Warning: always ensure that the nut 3 on each rod remains fully screwed
on the rod.
Secure the position of the projector/support by fastening the nuts 1 and 3.
Action
Loosen the safety-nut (C) on top and rear of the projector support.
Adjust the adjustable screw (A) on each side of the projector support to apply
small correction to the coarse water-level adjustment. (turning clockwise lifts up
the projector, counterclockwise lowers the projector)
Secure the position of the projector/support by fastening the safety-nuts (C).
B
CD
A
H
C
Nut 1
Nut 2
Nut 3
A
16 ————————————— Projection Systems
C