Fixing the the projector support on the Rods.
What has to be
After the pull belts are fixed to the projector support, the projector unit has to be pull up,
done
using the motor function, to be fixed to the rods, mounted in the ceiling plate.
Necessary Tools
Spanner 18mm
Fixating the
To fix the projector support on the rods, follow the next procedure:
support on the
rods
Step
1-
2-
3-
BARCO 15
Action
Pull up the projector unit, lining up manually the fixation holes (A) in the projec-
tor support with the respective rods (B), until the rods enter the holes in the
support for at least 1.5cm.
Secure the position of the projector support on the rods, using 2 nuts M12 (C)
for each rod.
Attention: for safety reasons, both nuts must be turned fully on the rods.
Turn the nuts (D) fully against the support without tightening and proceed to the
alignment of the motorized ceiling mount assembly.
B
D
A
C
D
Projection Systems
C