Table of Contents
Advertisement
Table 26. Cable routing for the power backplane and the intrusion switch
Intrusion switch cable
1
Power backplane sideband cable
2
Step 4.
Power on the server. Make sure the power LED (green) is lit.
Step 5.
(If available) Hook the front end of the switch cap to the power backplane, and rotate the other end
to secure the cap; then apply the label to the power backplane.
Figure 118. Applying the switch cap and label
After this task is completed
Proceed to complete the parts replacement (see
Power supply replacement
See these topics to learn how to remove and install a power supply unit.
From
Intrusion switch
Power backplane
Power LED (green)
1
Power switch
2
"Complete the parts replacement" on page
Chapter 3
To
Intrusion switch connector
Power backplane sideband connector
174).
.
Hardware replacement procedures
123
Advertisement
Table of Contents
