Table of Contents
Advertisement
Figure 133. Removing the security bezel
Press and hold the release latches on both sides.
Slide the security bezel away from the chassis.
After this task is completed
• Proceed to replace the dust filter if necessary (see
Remove the dust filter
See this topic to learn how to remove the dust filter.
About this task
Attention:
• Go over
"Installation Guidelines" on page 41
• Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Watch the procedure.
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DV_Ja2E7l6T-lwN_IrnJRk
Procedure
Step 1.
Make preparations for this task.
1. Remove the security bezel (see
Step 2.
Remove the dust filter.
to ensure that you work with safety.
13).
A video of this procedure is available from the following link:
"Remove the security bezel" on page
"Remove the dust filter" on page
.
Chapter 3
Hardware replacement procedures
139).
137).
139
Advertisement
Table of Contents
