Table of Contents
Advertisement
Figure 63. Removing a Torx T30 nut from the heat sink
Note: Do not touch the gold contacts on the bottom of the processor.
Rotate the anti-tilt wire bail inwards.
Push the upper edge of the Torx T30 nut towards the center of the heat sink until it
disengages.
Remove the Torx T30 nut.
Attention: Visually inspect the removed Torx T30 nut, if the nut is cracked or damaged, make sure
no debris or broken pieces are left inside the server.
After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a heat sink Torx T30 nut
See this topic to learn how to install a PEEK (Polyether ether ketone) Torx T30 nut on the heat sink.
About this task
Note: The heat sink, processor, and processor carrier for the system might be different from those shown in
the illustrations.
Watch the procedure.
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DV_Ja2E7l6T-lwN_IrnJRk
Procedure
Step 1.
Install the Torx T30 nut.
"Install a heat sink Torx T30 nut" on page
A video of this procedure is available from the following link:
83.
.
Chapter 3
Hardware replacement procedures
83
Advertisement
Table of Contents
