Table of Contents
Advertisement
Procedure
Step 1.
Make preparations for this task.
1. If applicable, remove the security bezel (see
2. Remove the top covers (see
3. Remove the air baffle (see
4. Remove both PCIe riser assemblies (see
page
100).
5. Remove the trayless drive cage (see
156).
6. Remove the system board assembly if necessary (see
on page
149).
Step 2.
Remove the two screws that secure the Firmware and TPM 2.0 Security Module to the system
board, and remove the module.
Figure 171. Removing the Firmware and TPM 2.0 Security Module
After this task is completed
• Install a replacement unit (see
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the Firmware and TPM 2.0 Security Module
See this topic to learn how to install the Firmware and TPM 2.0 Security Module.
About this task
Watch the procedure.
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DV_Ja2E7l6T-lwN_IrnJRk
"Remove the top covers" on page
"Remove the air baffle" on page
"Remove the drive cage and trayless drives" on page
"Install the Firmware and TPM 2.0 Security Module" on page
A video of this procedure is available from the following link:
"Remove the security bezel" on page
168).
43).
"Remove the PCIe riser assemblies and adapters" on
"Remove the system board assembly"
.
Chapter 3
Hardware replacement procedures
137).
167).
167
Advertisement
Table of Contents
