JLG 642 Operation & Safety Manual page 133

Installation Procedure:
• Ensure carriage is properly installed. Refer to "Attachment Installation" on page 5-9.
• Secure the fork mounted trash hopper to the forks by sliding the fork mounted trash
hopper onto the parent forks and install the retaining pin behind the vertical shank of
the fork.
Operation:
• Raise or lower boom to appropriate height for loading material.
• Travel in accordance with requirements set forth in Section 1—General Safety
Practices.
• To release gate, tilt fork mounted trash hopper down approximately 10 degrees and
engage bottom bumper on edge of dumpster. The gate will open allowing the
contents to slide out.
• Tilt fork mounted trash hopper back to close and secure the gate.
• Do not use with mast carriage attachment.
• Do not use fork mounted trash hopper with attachments capable of rotating (i.e. side
tilt carriages) without disabling the rotation feature(s).
Equipment Damage Precautions
• Except for lifting or dumping a load, the boom must be fully retracted for all fork
mounted trash hopper operations.
31211031
Section 5—Attachments
5-39