Sample Capacity Chart - JLG 642 Operation & Safety Manual

Section 5—Attachments

Sample Capacity Chart

JLG Supplied
Attachments
Attachment type,
weight and
dimensions must be
equal to or less than
the data shown.
XX" MAX
=XXX lbs.
MAX
Boom Angle
Load zones indicate maximum
weight that may be safely lifted.
Note: This is sample capacity chart only! DO NOT use this chart, use the one located in your
operator cab.
TIP OVER HAZARD. All loads shown on rated capacity chart are based on machine
being on firm ground with frame level (see page 4-9 or 4-12); the forks being
positioned evenly on carriage; the load being centered on forks; proper size tires being
properly inflated; and the telehandler being in good operating condition.
To identify the proper capacity chart on telehandlers equipped with outriggers, refer to
the following icons which may be located on the capacity chart.
• Use when lifting a load with outriggers up.
• Use when lifting a load with outriggers down.
5-6
Attachment
P/N:
XXXXXXXXXX–xx in.
XXXXXXXXXX–xx in.
XXXXXXXXXX–xx in.
XX
XX
XX
XX
XX
XX
XX
XX XX XX
WARNING
xxxxx
XX
XX XX XX
XXXXXX XXXXX
This Capacity Chart
may be used with this
model ONLY.
The telehandler model
is indicated on the
boom or chassis.
Model XXXX is used for
demonstration
purposes only.
Indication of
outrigger position.
Lifting capacity of
attachment only.
Boom Extension
Indicator (arc)
Load center must
be equal to or less
than value shown.
OD1060
OD1080
OD1070
31211031