Updating The Serial Number; Removing And Replacing The Appliance Module System Board - HPE Synergy 813562-001 Maintenance And Service Manual

6. Slide the appliance module into the bay until it clicks into place.
For an Image Streamer, see Reinserting Image Streamer.
7. Reimage the appliance module if you have also replaced the drive.
For more information, see Reimage the appliance.
8. If you replace the drive at the same time as the system battery, update the serial number.
If the appliance module is a member of a cluster, allow the appliance module to rejoin the cluster automatically. Rejoining the
cluster can take between 15 minutes to an hour. Do not remove the appliance module when it is rejoining the cluster.
If the appliance module is not a member of a cluster, restore the backup.
For more information about restoring the backup, see one of the following documents:
• HPE OneView User Guide for HPE Synergy on the Hewlett Packard Enterprise website at http://www.hpe.com/
support/OV-UGS
HPE Synergy Image Streamer User Guide on the Hewlett Packard Enterprise website at https//www.hpe.com/info/
•
synergy-docs
For more information about battery replacement or proper disposal, contact an authorized reseller or an authorized service
provider.

Updating the serial number

The component (CI Mgr) serial number is stored in iLO NVRAM. The serial number is stored in the disk on first boot after
installation or factory reset or reimage.
Prerequisites
Authorized service personnel need to update the serial number if:
• The system board (that contains iLO NVRAM) is replaced.
• The drive and the system battery are replaced at the same time.
Procedure
Authorized support personnel must log in to the appliance, create the required configuration file (/ci/etc/.warranty-serial-
number) with the correct serial number (from the label attached to the original system board) and reboot the appliance.
On appliance reboot, the serial number stored on the drive (/ci/etc/.warranty-serial-number) is written to iLO NVRAM.

Removing and replacing the appliance module system board

Prerequisites
• Make sure that you have a T-10 and a T-15 Torx screwdriver available.
Create and download a backup of the appliance module. For more information, see "Creating and downloading an
•
appliance backup."
• Prepare a USB flash drive with the currently installed image of the appliance module. For more information, see "Preparing
a USB flash drive for reimaging an appliance."
Create and download a support dump. For more information, see "Create a support dump file from the appliance
•
maintenance console."
Removal and replacement procedures
38