Removing the access panel
Before you perform this procedure:
•
Make sure you have a T-10 Torx screwdriver available.
•
Create and download a backup of the appliance module. For more information, see "Creating and downloading an
appliance backup."
•
Prepare a USB flash drive with the currently installed image of the appliance module. For more information, see "Preparing
a USB flash drive for reimaging an appliance."
•
Create and download a support dump. For more information, see "Create a support dump file from the appliance
maintenance console."
Procedure
1. Perform either of the following:
Remove the Composer from the frame.
•
•
Remove the Image Streamer from the frame.
2. Place the appliance module on a flat surface.
3. Remove the component as indicated.
Removing and replacing a drive
Prerequisites
Make sure that you have:
Removal and replacement procedures
29