Removing And Replacing Appliance Module Memory; Removing And Replacing The System Battery - HPE Synergy 813562-001 Maintenance And Service Manual

Removing and replacing appliance module memory

Before you perform this procedure:
Create and download a backup of the appliance module. For more information, see "Creating and downloading an
•
appliance module backup."
• Prepare a USB flash drive with the currently installed image of the appliance module. For more information, see "Preparing
a USB flash drive for reimaging an appliance module."
• Create and download a support dump. For more information, see "Create a support dump file from the appliance
maintenance console."
Procedure
1. Perform either of the following:
• Remove the Composer from the frame.
• Remove the Image Streamer from the frame.
2. Flex the two metal latches on the memory socket. They will pop up at an angle.
3. Pull the memory straight out.
4. To replace the component, reverse the removal procedure.
5. Slide the appliance module into the bay until it clicks into place.
For an Image Streamer, see "Guidelines for inserting an Image Streamer."
If the appliance module is a member of a cluster, allow the appliance module to rejoin automatically the cluster. Rejoining
the cluster can take between 15 minutes to an hour. Do not remove the appliance module when it is rejoining the cluster.

Removing and replacing the system battery

If the appliance module no longer automatically displays the correct date and time, then replace the battery that provides
power to the real-time clock. Under normal use, battery life is 5 to 10 years.
Removal and replacement procedures
36