Setup - QMS VMS Software Manual

Option Purpose
RIGHT= n Specifies the number of columns to be left blank between
the /WIDTH setting and the actual print image area. The n
parameter must be a positive integer between 0 and the
value of the /WIDTH parameter. When determining the /
RIGHT parameter, start at the /WIDTH value and count to
the left. The default value is 0, which means that the print
image extends as far to the right as the /WIDTH value.
TOP= n Specifies the number of blank lines to leave between the top
of the physical page and the start of the print image. The n
parameter must be a positive integer between 0 and the /
LENGTH parameter. The default value is 0, which generally
means that there is no top margin.
The DEFINE/FORM command qualifier /PAGE_SETUP specifies one
or more modules that set up the device at the start of each page:
$ DEFINE/FORM/PAGE_SETUP=( module [,...])
The modules are located in the device control library. While the form
is mounted, the system extracts the specified module and copies it to
the printer before each page is printed.
The DEFINE/FORM command qualifier /SETUP specifies one or
more modules that set up the device at the start of each file:
$ DEFINE/FORM/SETUP=( module [,...])
The modules are located in the device control library. While the form
is mounted, the system extracts the specified module and copies it to
the printer before each file is printed.