Table of Contents
Advertisement
This chapter takes you step-by-step through the installation of the
QMS host software for host-, LAT-, or serial/parallel-connected print-
ers.
Before installing the host software, ensure that the designated system
port is identified and properly configured for the target printer port to
be used.
If you're updating your host software from a previous version and you
want to save predefined set-up files, move them from the old device
control library at this time. To do this, use the following commands:
$ library/extract=module_name -$ _$
SYS$LIBRARY:QMS$DEVCTL20.TLB -
_$/OUT=module_name.tmp
A Device Control Library update utility has been provided in the
sys$common:[sysmgr] directory. To run this procedure, type:
$ @sys$common:[sysexe]qms$update_lib
Note: This procedure provides a user-friendly method of copying
»
library modules from one Device Control Library to another. Additional
information is displayed when this procedure is run.
Advertisement
Table of Contents
