QMS VMS Software Manual page 38

2 Type the following commands:
$ SET DEF SYS$COMMON:[sysexe]
$ @qms$inithsl
» Note: This command procedure works without modification for
most sites but you should review the command procedure before
running.
Once these two steps are completed, the HSL application is active
and ready to receive printer error and backchannel messages.
The HSL installation routine checks for DECnet Phase V. If Phase V is
detected, NCL creates the HSL session control application on the
running system. The NCL command procedures used by the system
at start-up to configure the network are appended with the necessary
information for generating the HSL application at system start-up
time.
Phase V HSL installation prompts are as follows:
Checking NCL for the existence of the session
control application HSL
If HSL has already been installed, you'll see this message:
The session control application HSL is already
defined!
If HSL has not been previously installed, you'll see this message:
Creating the session control application HSL