Table of Contents
Advertisement
starting the range are compiled but are not printed. Pages that come
after the last page in the range are flushed without being compiled.
The default range is one page.
The PAGE_MARGIN parameter defines the usable area of the sheet
in which logical pages may be placed. The margins established by
this parameter take effect after the sheet has been oriented by the
ORIENTATION parameter.
The PAGE_OFFSET parameter is used to offset the logical page
within its page spot. This parameter takes effect after the sheet has
been oriented by the ORIENTATION parameter and after the page
grid has been defined by the PAGE_GRID parameter. See your QMS
Document Option Commands manual for more information about this
parameter.
The PAGE_SCALING parameter scales the logical page to fit within
its page spot. The aspect ratio of the page is maintained during scal-
ing, reducing or expanding the page's width and height in the same
proportions. Valid values for this parameter are off and on. See your
QMS Document Option Commands manual for more information
about this parameter.
You have three ways to print multiple copies of your files:
n
The SHEET_COUNT parameter prints n uncollated copies of
each page of every file in your job regardless of the collation set-
ting in the printer's configuration menu. The range of values for
SHEET_COUNT is 1 to 10,000.
$ PRINT/PARAMETERS=(SHEET_COUNT= n ) filename.typ
Advertisement
Table of Contents
