Table of Contents
Advertisement
Use either the Phase V or Phase IV instructions that follow, depend-
ing on your site.
Successful installation of this product under
DECnet-OSI (Phase V) requires that you have
already defined a node name and address to be
used with the printer you are installing. (The
Installation Verification Procedure will fail
otherwise.) You will be asked for the node name
later in this installation procedure.
If you have not already done so, you should make
sure that the DECnet address entered at the
printer control panel matches the address for
the printer's node name as defined on the host.
Consult your printer user's manual for
information on setting control panel options.
The printer address has been set [YES]?
The program next prompts you for the printer node name:
* Enter a node name for the QMS printer:
Enter the node name of the QMS printer you're updating.
Note: Be careful not to end the node name with a single colon (:).
»
Otherwise, the symbiont will assume a port connection.
Once you've specified a node name, the program asks you to verify
your selection:
* Accept name node_name ?
Press Enter if the displayed node_name is correct. If you want to
change it, type N.
Advertisement
Table of Contents
