MINOLTA-QMS PagePro 4100E User Manual page 99

6-2 Host-based lpd Configuration
2. What is the node name of the Print Server Unit?
Input the host name recorded in
and then press
printfast
3. What is the printer name?
Type the printer name and press
4. Here, the script displays the information you have input up to this
point. The following shows example information.
Node name of the Printer Server Card:
printfast
Printer name to be used: <printer name>
The printer is attached on: PORT 1
Check these settings and make sure they are correct. If they are
correct, type yes
.
Enter
5. Configure a virtual printer using <printer name> as the physical
device. For <printer name>, use the same printer name that you
specified when installing the printer.
6. Use the following command to shut down qdaemon.
stopsrc -s qdaemon
7. Edit
/usr/lpd/qconfig
name from /dev/ <printer name>
8. Use the following command to restart the daemon.
startsrc -s daemon
After this, the installation script creates a named pipe and starts up a
print daemon based on the printer name and Network Card information
you supplied. The AIX System Management Interface Tool (SMIT)
does not accept the named pipe as a printer device, so the install script
also creates a null character device in
6-24
/etc/hosts
.
Enter
Enter
and press . Otherwise, type
Enter
to change the special file for device printer-
to
/dev/ <printer name>
. For example, type
.
no and press
/dev/nic/ <printer name> .
.