MINOLTA-QMS PagePro 4100E User Manual page 111

7-4 Assigning IP Addresses Using the RARP Daemon (For
00:40:AF:03:AF:6E
4. If the RARP daemon is already running, stop it.
5. Power up the printer.
The printer initializes, recognizes the IP address, and stores it in
non-volatile memory.
6. After the printer is fully started, power it down again.
7. Power the printer back up, and use the following command to ping
the Network Card.
ping <IP address assigned to Network Card>
Example:
IP Address: 192.9.200.200
ping 192.9.200.200
The following response is returned when the IP address is
assigned properly.
192.9.200.200 is alive
8. After assignment is complete, delete the lines you added to
. You can also stop the RARP daemon.
/etc/ethers
Note
• When the Network Card host name is already registered in the hosts
file (
/etc/hosts
• RARP can be used to assign an IP address only. Other IP parameters
must be set using Telnet or a Web browser. For details, see Chapter 10
- Using Telnet to Make Settings and Chapter 9 - Using a Web Browser
to Make Settings.
7-8
), you can use the host name in place of the IP address.
192.19.200.200