MINOLTA-QMS PagePro 4100E User Manual page 93

6-2 Host-based lpd Configuration
The above example reflects the name supplied to the script earlier.
After the installation script is complete, you must then configure the
printer and make it known to the lp system. The HP-UX lp system uses
the lpadmin command used to configure a printer. There is no
file. The following are the commands used for printer
printcap
configuration.
lpadmin -p <printer name> -v /dev/nic/
<printer name>
enable <printer name>
accept <printer name>
You can also use other options in the lpadmin command. See your
system documentation for details.
Note
• The printer name must be the same as the one you specified during
Network Card installation. HP also provides the sam program, which
can be used to configure the printer.
If you use sam, make all specifications just as if the printer were
connected directly to /dev/lprinter/<printer name>.
The software installed with your HP system should be sufficient to
satisfy most printing needs. HP supplies ASCII-to-PostScript filters
that are invoked automatically whenever PostScript is specified as the
content type. The HP-UX lp system also supplies interface scripts that
generate PostScript banners. When necessary, you can use the lpfilter
command to define new filters and content types. The installation
provides you with the full power and flexibility of the lp print service,
and the fact that you are printing across the network is totally
transparent.
6-18
/etc/