MINOLTA-QMS PagePro 4100E User Manual page 162

Ethernet Frame Type
Specify the frame type being used by Ethernet. Normally, the
frame type being used by NetWare is determined by monitoring
the Network Card. When the frame type is determined, it is
assumed that the Network Card is the same frame type. Once you
select a frame type, Network Card operation supports that Net-
Ware frame type only.
Frame type monitoring normally starts from IEEE 802.3, and then
moves to Ethernet II and then 802.3 SNAP. When the network you
are on uses multiple Ethernet frame types, use the pull-down menu
to select the frame type to be recognized.
Disable Bindery
Check this option to disable bindery when only the NDS mode is
used. When bindery is disabled, the Network Card no longer sup-
ports the print server on the bindery file server.
Click the button at the bottom of the page to apply any
Apply
changes you make.
The settings you make on this page do not become valid until you
reset the Network Card or power it down and then pack up again.
See 9-4-7 Reset for more information on resetting the Network Card.
Status
Click to jump to the NetWare Status page.
9-4 Network Card Settings
9-17