MINOLTA-QMS PagePro 4100E User Manual page 39

3-2 Windows NT
Configuration Procedure
1. Install TCP/IP under Windows NT.
See A-3-1 Installing and Setting Up the TCP/IP Protocol and the
applicable Windows documentation for more information.
2. Assign the IP parameters.
See Chapter 7 - Setting Up IP Parameters for more information.
3. Install the IP Peer-to-Peer Printing Program.
Use the IP Peer-to-Peer Printing Program for peer-to-peer printing.
See 8-2-1 IP Peer-to-Peer Printing Program (Windows) for more
information.
4. Use the procedure below to install the printer.
To install the printer
1. Load the CD-ROM that comes with your printer into your com-
puter's CD-ROM drive.
2. Click the Install Printer Driver
3. Click the
PCL Driver
printer the default printer.
See the User's Manual of the printer for details about how to
install it.
4. Right-click the new printer icon and select
menu.
5. Display the
Ports
6. From the Print to the following port(s)
the printer IP address is displayed.
7. Click the
OK
8. Right-click the printer icon again to display its
box, display the
9. If the test prints normally, complete the procedure by clicking
to close the
Properties
After you finish installing a printer with the above procedure, you can
use it just as you would any standard local printer. The printer can also
be used as a network printer by other Windows computers on your
network whose Windows NT 4.0 systems are configured the same way
as described above.
3-6
menu and install the printer. Make the new
tab.
button of the
Properties
tab, and then print a test page.
General
dialog box.
menu on the opening screen.
Properties
list, select the port where
dialog box to close it.
Properties
from the
dialog
OK