Hp-Ux System - MINOLTA-QMS PagePro 4100E User Manual

7. This completes the installation. In response to the message about
whether you want to install another printer, input
then press
Enter
Like all BSD systems, ULTRIX uses the
a printer. The interface to the installation script is the same for all BSD
systems, but the printcap entry is different.

6-2-5 HP-UX System

1. Type the following command to run the installation script.
nicinst
The script automatically downloads the appropriate Network Card
utilities for your system and displays questions to prompt you for
the information it needs.
2. What is the node name of the Print Server Unit?
Type the host name recorded in
and then press
printfast
3. What is the printer name?
Type the printer name and press
4. Here, the script displays the information you have input up to this
point.
Node name of the Printer Server Card:
printfast
Printer name to be used: <printer name>
The printer is attached on: PORT 1
Check these settings and make sure they are correct. If they are
correct, type
yes
.
Enter
5. The script automatically starts the daemon for the newly config-
ured printer. At this time, the script displays the path you should
use if you ever need to restart the daemon.
Example:
/usr/nic/lpr_print /dev/nic/ <printer name>
printfast 10001 &
6-2 Host-based lpd Configuration
.
/etc/hosts
.
Enter
Enter
and press . Otherwise, type
Enter
or
yes
file to configure
/etc/printcap
. For example, type
.
and press
no
and
no
6-17