Icom IC-T10 Advanced Manual page 29

5
SET MODE
Initial Set Mode items
Beep level
Selects a key-touch beep level.
The key-touch beep level is linked to the audio output
level.
• Options: OFF, 1 (Min) ~ 3 (Max)
Time-out timer
Selects whether or not to enable the Time-Out Timer.
The function inhibits continuous transmissions longer
than this set period of time.
• OFF: Turns OFF the function.
• 1 ~ 30: The transmission is cut OFF after the
set period of time ends.
Auto repeater
(For only the USA version)
The Auto repeater function automatically turns the
duplex operation and tone encoder ON or OFF. The
offset and repeater tone settings are not changed by
the auto repeater function. Reset these frequencies, if
necessary.
• OFF: Turns OFF the function.
• R1: Turns ON only the duplex operation.
• R2: Turns ON the duplex operation and
Tone encoder.
(Default: 2) Auto power OFF
Selects whether or not to automatically turn OFF the
transceiver after inactivity for this set period of time.
• OFF:
• 30/1H/2H:
(Default: 5)
Lockout
Selects whether or not to enable the Busy Lockout
function.
(Default: R1)
• OFF:
• RPt:
• bUSy:
Squelch delay
Selects a squelch delay option. The delay prevents
the squelch from repeatedly opening and closing,
while receiving the same signal.
• LOnG:
• SHORt:
5-7
Does not turn OFF the transceiver.
Turns OFF the transceiver after
inactivity for this set period of time.
L " " is displayed in Standby mode.
L Beeps sound for 5 seconds before
turning OFF the transceiver. If you
operate the transceiver during this
period of time, the Auto Power OFF
timer is reset.
Transmittable even while receiving.
Inhibits transmission if the received
signal does not include the
programmed tone.
Inhibits transmission while receiving.
(Default: LOnG)
Long squelch delay.
Short squelch delay.
(Default: OFF)
(Default: OFF)