Table of Contents
Advertisement
5
SET MODE
Set Mode items
Frequency offset
Sets the difference between the transmit and receive
frequencies for Repeater operation or Duplex
operation.
• Range:
Set to between 0.000 and 20.000 (MHz).
* The default value may differ, depending
on the frequency band.
Duplex reverse
Selects whether or not to reverse the Duplex
frequency.
• OFF:
Normal Duplex communications.
• On:
Reverse the Duplex frequency.
Tuning step
Selects a tuning step. In the VFO mode, when you
select the operating frequency by rotating [DIAL], the
frequency changes in this selected tuning step.
It also applied for a VFO scan.
• Options:
5.0, 10.0, 12.5, 15.0, 20.0, 25.0, 30.0,
50.0, 100.0, 125.0, and 200.0 (kHz)
* A default value may differ, depending
on the transceiver version.
Priority scan
Selects whether or not to enable the Priority Scan
function and Priority Bell.
• OFF:
Turns OFF the function.
• On:
Turn ON the function.
• bELL:
When a signal is received while
operating the Priority Scan, a bell
sounds and "
(Default: 0.600*)
(Default: OFF)
(Default: 5.0*)
(Default: OFF)
" blinks.
5-4
Tone scan
Selects whether or not to enable the Tone Scan
function.
• OFF:
Turns OFF the function.
• On:
Detects the Tone frequency or
DTCS code used by the transceiver
that communicates using the Tone
Squelch function.
Pause timer
Selects a Scan Pause Timer. When a signal is
received during a scan, the scan pauses for the set
period of time, and then resumes.
• 5:
The scan pauses for 5 seconds, and
then resumes.
• 10:
The scan pauses for 10 seconds, and
then resumes.
• 15:
The scan pauses for 15 seconds, and
then resumes.
• P-2:
The scan pauses until the received
signal disappears, and then resumes
after 2 seconds.
Program skip scan
Selects whether or not to enable the Program Skip
Scan function for a VFO mode scan.
This function enables the transceiver to skip the
unwanted frequencies that are entered as a Memory
channel and are set to "PSKIP."
• OFF:
The transceiver scans all
frequencies.
• On:
The transceiver does not scan
frequencies set as "PSKIP"
frequencies.
(Default: OFF)
(Default: 15)
(Default: On)
Advertisement
Chapters
Table of Contents
