AJAX MotionProtect Plus Fibra User Manual page 16

MotionProtect Plus Fibra only works with one hub. When connected to a new
hub, the detector stops exchanging commands with the old one. Once added to
a new hub, MotionProtect Plus Fibra is not removed from the list of devices of
the old hub. This must be done through the Ajax app.
Malfunctions
When a detector identi es a malfunction (for example, there is no connection
via the Fibra protocol), the Ajax app displays a malfunction counter in the upper
left corner of the device icon.
All faults can be seen in the detector states. Fields with malfunctions will be
highlighted in red.
Malfunction is displayed if:
The detector temperature is out of acceptable limits.
The detector body is open (tamper is triggered).
There is no connection with the hub via the Fibra protocol.
Icons
The icons display some of MotionProtect Plus Fibra states. You can view them
in the Ajax app on the Devices tab
Icon
Fibra signal strength, displays the signal strength between the hub and the
detector. The recommended value is 2—3 bars.
Learn more (in progress)
The detector operates in the Always Active mode.
Learn more
Entry and/or exit delay is enabled.
Learn more
.
Meaning