Kohler SV810-840 Service Manual page 91

Figure 7-66. Torquing Brush Holder Screws.
the drive lever, and install the spring into the
through the holes in the drive end cap. Use these
to hold the solenoid gasket in position, then
mount the solenoid. Torque the screws to
to the solenoid and secure with the hex nut.
Torque the nut to
Figure 7-67. Positive (+) Brush Lead Connection.
.
Electrical System and Components
Solenoid Test Procedure
Solenoid Shift Style Starters
Remove the mounting hardware and separate the
solenoid from the starter for testing.
Test 1. Solenoid Pull-In Coil/Plunger Actuation
Test.
to the solenoid for any time over what is
necessary for performing each of the
solenoid may otherwise occur.
Figure 7-68. Testing Pull-In Coil/Plunger Actuation.
Section 7
7
12 volt Test Leads
Momentary
Connection Only
7.35