Kohler SV810-840 Service Manual page 48

Section 5
Fuel System and Governor
and seat. If dirty, blow out with compressed air.
kit.
8. Using new gaskets, reinstall the bowl and tighten
the bowl retaining screw or solenoid to
5.1-6.2 N·m (45-55 in. lb.).
9. Reinstall the carburetor on the engine, reconnect
the fuel line, control linkages and air intake
components. Retest operation.
Disassembly
number and the Nikki lot number are stamped on
Refer to the parts manual for the carburetor involved
to ensure the correct repair kits and replacement parts
1. Remove the fuel bowl retaining screw or solenoid
assembly, then remove the bowl and bowl gasket.
mounted in the tip of the solenoid pin. Be careful
that it does not get damaged while the solenoid is
separated from the carburetor.
5.16
solenoid-equipped carburetors.
carburetor body.
assembly out of the carburetor body. Disassemble
cover to the body, remove the cover gasket.
if it does not have a limiter. Remove the idle
considered non-serviceable, the carburetor is now
completely disassembled and ready for thorough
inspection and cleaning.