Kohler SV810-840 Service Manual page 41

to return to the governed idle speed. Check
it with a tachometer against the equipment
manufacturers recommended idle speed.
(approximate) higher than the low idle speed. If
on the speed control assembly to set.
Governed
Idle Spring
Figure 5-7. Governed Idle Spring Location.
Hold Throttle
Lever Against
Screw
Figure 5-8. Holding Throttle Lever Against Idle Stop
Screw.
Carburetor Servicing
Keihin Carburetors
Float Replacement
1. Clean the exterior surfaces of dirt or foreign
material before disassembling the carburetor.
Remove the four fuel bowl screws and carefully
separate the fuel bowl from the carburetor. Do not
fuel into an approved container. Save all parts. See
Figure 5-9. Fuel Bowl Removed from Carburetor.
Tab
Discard all of the parts. The seat for the inlet
needle is not serviceable, and should not be
removed.
Figure 5-10. Removing Float and Inlet Needle.
required, before installation of new parts.
metal tang should point up, with the needle valve
Fuel System and Governor
Section 5
5
5.9