Kohler SV810-840 Service Manual page 44

Section 5
Fuel System and Governor
Figure 5-18. Installing Main Nozzle and Main Jet.
Figure 5-19. Installing Slow Jet.
Figure 5-20. Installing Plug into Slow Jet Tube.
metal tang should point up, with the needle valve
hanging down
5.12
Figure 5-21. Float and Inlet Needle.
seat and carburetor body. Insert the new pivot
Figure 5-22. Installing Float Assembly.
hangs vertically and rests lightly against the
fuel inlet needle. The inlet needle should be
fully seated but the center pin of the needle (on
retainer clip end) should not be depressed. Check
rests against the fuel inlet needle,
without depressing the center pin.
(0.472 in.)
12.0 mm