Kohler SV810-840 Service Manual page 82

Section 7
Electrical System and Components
Figure 7-34. Assembling Larger Inner Half Around
Spring Retainer.
around the retaining ring. Stop turning when
tool.
Starter Disassembly
instructions for servicing the drive.
frame.
End Cap/Brush Replacement
installation is performed, the end of the armature
commutator. Do not remove the protective tape and
7.26
Commutator Service
not use emery cloth.
down on a lathe or replace the starter.
Starter Reassembly
end of the armature. The magnets will hold the
armature inside the frame.
align with cutout the starter frame. See Figure
Figure 7-35. Aligning End Cap and Frame.
Thrust Washer (Cup)
Thin Shipping Strip
Figure 7-36. Assembling Commutator End Cap
onto Armature.
Alignment Notches
carefully remove the
Do not allow the thrust
Tape