Kohler SV810-840 Service Manual page 31

Air Cleaner Base
Disassembly/Reassembly
If the air cleaner base requires removal, proceed as
follows:
1. Remove the mounting screws for the fuel pump
(if equipped), and the blower housing.
2. Raise or remove the blower housing for access to
the air cleaner base.
3. Remove the air cleaner components from the
base. See Figure 4-3.
cleaner base onto the mounting studs.
5. Disconnect the breather hose from the air cleaner
base, then remove the base and gasket.
6. Reverse procedure to reassemble components.
(55-65 in. lb.). Torque the blower housing screws
to 4.0 N·m (35 in. lb.), and the two front HI-LO
screws to 2.8 N·m (25 in. lb.).
Air Cleaner and Air Intake System
Air Intake/Cooling System
To ensure proper cooling, make sure the grass screen,
engine are kept clean at all times.
Annually or every 100 hours
under extremely dusty or dirty conditions), remove
the blower housing and other cooling shrouds. Clean
Make sure the cooling shrouds are reinstalled.
NOTE: Operating the engine with a blocked grass
6.2-7.3 N·m
cooling shrouds removed, will cause engine
damage due to overheating.
Section 4
4
4.3