Kohler SV810-840 Service Manual page 89

grommet, into the matching recess of the drive
end cap. The molded recesses in the grommet
Figure 7-58. Installing Backup Washer and
Grommet.
notch with the corresponding section in the
cutout, if it was removed previously. See Figure
Figure 7-59. Installing Frame and Drain Tube.
Electrical System and Components
Figure 7-60. Installing Thrust Washer.
end housing, and carefully position the
place around the commutator, and install the
servicing.
Figure 7-61. Installing Brush Holder Assembly with
Supplied Tube.
the springs.
Section 7
not
7
7.33