Kohler SV810-840 Service Manual page 46

Section 5
Fuel System and Governor
Choke Repair
1. Remove the carburetor from the engine. Discard
the old mounting gaskets for the air cleaner and
carburetor.
self-relieving choke mechanism thoroughly.
4. Note the position of the spring legs and the choke
plate for correct reassembly later. See Figure
carburetor body and discard the removed parts.
Figure 5-28. Choke Details.
lever from the carburetor housing. Save the
bushing to use as a driver for installing the new
bushing. Discard the old lever.
required.
7. Insert the new bushing through the new choke
lever from the outside, and start the bushing
so that the protruding boss on the carburetor
housing is between the two stops formed in the
5.14
Figure 5-29. Assembling Choke Lever.
8. Turn the old bushing upside down and use it
as a driver to carefully press or tap the new
Check that the choke lever pivots freely without
Figure 5-30. Installing Bushing.
9. Install the new return spring onto the new choke
the two formed stops on the end of the choke
this location during the following step.