Kohler SV810-840 Service Manual page 117

Governor Assembly (Internal)
Inspection
Inspect the governor gear teeth. Replace the gear if it
is worn, chipped, or if any teeth are missing. Inspect
the governor weights. They should move freely in the
governor gear.
Disassembly
The governor gear must be replaced once it is
removed from the oil pan.
small molded tabs in the gear. When the
are destroyed and the gear must be replaced.
Therefore, remove the gear only if absolutely
necessary.
1. Use two small screwdrivers and carefully pry
upward to remove the regulating pin and
governor gear assembly. See Figure 9-12.
Figure 9-12. Removing Governor Gear.
2. Remove the locking tab thrust washer located
under the governor assembly.
depth shown in Figure 9-13.
Inspection and Reconditioning
34.0 mm (1.3386 in.)
33.5 mm (1.3189 in.)
Figure 9-13. Governor Shaft Press Depth.
Reassembly
1. Install the locking tab thrust washer on the
2. Position the regulating pin within the governor
See Figure 9-14.
Figure 9-14. Installing Thrust Washer, Regulating
Pin and Governor Gear Assembly.
Oil Pump Assembly
Disassembly
9-15.
Figure 9-16.
Section 9
Gear Shaft
19.40 mm (0.7638 in.)
Thrust
Washer
(Tang
Down)
9.11
9