Kohler SV810-840 Service Manual page 81

the collar over the inner halves to hold them in
position.
Figure 7-31. Assembling Inner Half of Removal
Tool Around Armature Shaft and Retaining Ring.
The resistance against the center screw will tell
you when the retaining ring has popped out of
Figure 7-32. Holding Tool and Turning Center
Screw (Clockwise) to Remove Retaining Ring.
splines are dirty, clean them with solvent.
Electrical System and Components
52 357 01-S
order they were removed.
Figure 7-33. Splines on Armature Shaft.
Retaining Ring Installation
top and slide on the outer collar.
the retaining ring inside is resting on the end of
slight pressure toward the starter. Tap the top
of the tool with a hammer until you feel the
and remove the tool.
compress it into the groove.
the collar over them and thread the center screw
in until resistance is felt.
Section 7
7
7.25